Roto-fab aluminum engine covers will set your engine bay apart from the crowd. Our engine covers are hand fabricated from 1/8 inch aluminum, then the mounting brackets are TIG welded on using a fixture to insure proper fit to your car. Each cover has four mounting points and uses GM rubber isolators at the fastening points. The top mounts capture the fuel rail while the bottom mounts snap onto studs in the valve cover. After initial stud installation the covers go on/off without tools.
Due to variations in S/C coolant lines and reservoirs, installation instructions are not provided for this product. It is the installer’s responsibility to ensure there is at least 1/2 inch of clearance between the covers and any coolant lines or harnesses. Failure to do so could result in damage to components.The covers are available bare or in automotive colors for a custom touch. Please allow up to a 4 week lead time for automotive painted finishes. Specify color when ordering.Covers may vary in appearance from pictures